Table of Contents
Advertisement
Operation
Fire hazard.
Do not leave the Tepan plate unat-
tended whilst it is being used.
Please note that the heating-up time
for induction hobs is much shorter
than on conventional hobs.
Switching on the Tepan plate
Touch the sensor control.
Further sensor controls will light up. If
no further entry is made, the Tepan
plate will switch itself off after a few
seconds for safety reasons.
Setting the power level
Touch the appropriate sensor control
on the respective numerical keybank
for the power level you want.
Switching off
To switch off a cooking zone, touch
the 0 sensor on the numerical key-
bank for that zone.
To switch off the Tepan plate and
thus both cooking zones, touch
the sensor control.
20
Residual heat indicator
If the SmartLine element is still hot, the
residual heat indicator will light up after
it has been switched off. Depending on
the temperature, a dot will appear
above power levels 1, 2 and 3.
The dots of the residual heat indicator
go out one after the other as the Smart-
Line element cools down. The last dot
only goes out when the SmartLine ele-
ment is safe to touch.
Danger of burning.
Do not touch the SmartLine element
whilst the residual heat indicators are
lit up.
Advertisement
Table of Contents
