Scanning Sequence Examples; Errors While Scanning; User Preferences/Miscellaneous Options Parameter Defaults - Symbol DS6708 Product Reference Manual

4 - 2 DS6708 Digital Scanner Product Reference Guide

Scanning Sequence Examples

In most cases, scanning one bar code sets the parameter value. For example, to set the beeper tone to high,
scan the High Frequency (beeper tone) bar code listed under
issues a fast warble beep and the LED turns green, signifying a successful parameter entry.
Other parameters, such as Serial Response Time-Out or Data Transmission Formats, require scanning
several bar codes. See these parameter descriptions for this procedure.

Errors While Scanning

Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.

User Preferences/Miscellaneous Options Parameter Defaults

Table 4-4 lists defaults for user preferences parameters. There are two ways to change the default values:
Scan the appropriate bar codes in this guide. These new values replace the standard default values in
•
memory. To recall the default parameter values, scan the
• Configure the digital scanner using the 123Scan configuration program (see
See
NOTE
and miscellaneous default parameters.
User Preferences Parameter Defaults
Table 4-4
Parameter
User Preferences
Set Default Parameter
Parameter Scanning
Beeper Tone
Beeper Volume
Power Mode
Time Delay to Low Power Mode
Trigger Mode
Picklist Mode
Decode Session Timeout
Timeout Between Decodes, Same
Symbol
Appendix A, Standard Default Parameters
Paramete
r Number
ECh
91h
8Ch
80h
92h
8Ah
F0h 92h
88h
89h
Beeper Tone on page
Set Default Parameter on page
Chapter 12,
for all user preferences, hosts, symbologies,
Page
Default
Number
All Defaults 4-4
Enable 4-4
Medium 4-5
High 4-6
Continuous On 4-6
1 Minute 4-7
Auto Aim 4-8
Disabled Always 4-9
9.9 Sec 4-10
0.6 Sec 4-10
4-5. The digital scanner
4-4.
123Scan).