Siemens SINUMERIK 802C Manual page 74

Start-Up
4.7 Commissioning
Once entered, these data are immediately written to the data memory.
The machine data are activated depending on the Activation setting of the appropriate ma-
chine data, Section 4.1.2.
Note
Since these data are only stored in the memory backed up for a limited period of time, a data
backup is necessary (see Section 4.1.4).
Machine data
The following machine data list contains all general and other machine data and setting data,
which can be changed if necessary.
Number
10074 Division ratio of the PLC task factor for main run
11100 Number of auxiliary function groups
11200 Standard machine data loaded on next Power On
11210 MD backup of changed MD only
11310 Threshold for direction change of handwheel
11320 Handwheel pulses per detent position (handwheel number): 0...1
20210 Maximum angle for compensation blocks with TRC
20700 NC-Start disable without reference point
21000 Circle end point monitoring constant
22000 Auxiliary function group (aux. fct. no. in channel): 0...49
22010 Auxiliary function type (aux. fct. no. in channel): 0...49
22030 Auxiliary function value (aux. fct. no. in channel): 0...49
22550 New tool compensation for M function
Setting data
Number
41110 Jog feedrate
41200 Spindle speed
42000 Start angle
42100 Dry run feedrate
4-74
Description
Explanation
Default
Value
2
1
O
H
0FH
2
1
100
1
0.01
1
""
0
0
Default-
Value
0
0
0
5000
SINUMERIK 802C
6FC5 597–3AA20–0BP2 (01.02)