NordicTrack SE 3i User Manual page 9

7. Orient the Front Upright Cover (26) so that the
word "UP" is at the top.
Attach the Front Upright Cover (26) to the
Rear Upright Cover (25) with two M4 x 16mm
Screws (78).
8. Using a plastic bag to keep your fingers clean,
apply a generous amount of the included grease
to the axles on the Upright (2).
Next, slide a Pivot Spacer (55) onto the right
axle on the Upright (2). Then, identify the Right
Upper Body Arm (10), orient it as shown, and
slide it onto the right axle on the Upright.
Attach the Right Upper Body Arm (10) with an
M8 x 20mm Screw (84) and an M8 Washer (83).
Repeat this step on the other side of the
elliptical.
9. Identify the Right Rear and Front Arm Covers
(20, 21), and orient them as shown.
Press the Right Rear and Front Arm Covers
(20, 21) together around the Right Upper Body
Arm (10), and attach them with two M4 x 16mm
Screws (78). Tip: Attach the lower Screw first,
and then attach the upper Screw.
Repeat this step on the other side of the
elliptical.
7
25
8
9
20
9
26
78
2
55
83
84
Grease
10
78
21
10