NordicTrack SE 3i User Manual page 11

12. Identify the Rear and Front Leg Covers (38, 39),
and orient them as shown.
Press the Rear and Front Leg Covers (38, 39)
together around the right Upper Body Leg (13),
and attach them with three M4 x 16mm Screws
(78); start the center Screw first, and then
start the other two Screws. Then, tighten all
the Screws.
Repeat this step on the other side of the
elliptical.
13. Orient the Console Plate (92) as shown and hold
it near the Upright (2).
Next, insert the Main Wire (89) in the Upright (2)
through the Console Plate (92).
Tip: Avoid pinching the Main Wire (89). Attach
the Console Plate (92) to the Upright (2) with
four M4 x 10mm Screws (95); start all the
Screws, and then tighten them.
12
13
89
Avoid pinching
the Main Wire (89)
11
78
13
39
38
92
2
95