Motion Set; Video Mode - Swann DVR4-1100 User Manual

MOTION SET

MOTION RECORD TIME:
MOTION ALARM TIME:
MOTION SET
PRESS (UP, DOWN), ENTER (SELECT)
PRESS (MENU)
MOTION SET:
MOTION DETECTION SET
>CHANNEL 1 SENSITIVITY
CHANNEL 2 SENSITIVITY
CHANNEL 3 SENSITIVITY
CHANNEL 4 SENSITIVITY
CHANNEL 1 AREA SET
CHANNEL 2 AREA SET
CHANNEL 3 AREA SET
CHANNEL 4 AREA SET
PRESS (UP, DOWN), ENTER (SELECT)
PRESS (MENU)
AREA SET:
Use [ Up] and [ Down] button to select the channel you want to modify, press
[ SEL] button to enter the sensitive area of each camera. The picture of the
selected channel is divided into 144(12*12) blocks, press [REW] to move left,
press [FWD] to move right, press[ Up] and [ Down] to move the cursor up and
down, press [ SEL] to set the block active or not.
When the block is transparent, it's active to record. When the block is covered
by shadow, it is not active, and motion in this area will NOT be detected.
Make sure Record Schedule is set to Motion for the times required.

5.15 Video Mode

Select NTSC or PAL video system.
10
OFF
TO EXIT
4
4
4
4
TO EXIT
SENSITIVITY:
Use [ Up] and [ Down] button to
select the channel you want to modify,
press [ SEL] to adjust sensitivity of
motion detection on each channel.
High (1----------9, OFF) Low
When it's "OFF", the channel cannot
be triggered by motion.
- 11 -
User's Manual