Camera Management: Motion - Swann hdr8-8050 Instruction Manual

Camera Management: Motion

Motion detection is the default recording mode for the DVR. The entire view of the
camera is enabled to detect motion however you can select certain areas if you wish.
You will see a grid of red boxes. The boxes mark the areas that are sensitive to motion.
The areas without the boxes are not sensitive to motion.
• Use the mouse and left-click an area in the grid to toggle motion detection on and
off in that particular area
• Click and drag to select the area that you want select or deselect
Camera: Select a camera that you would like to edit.
Enable Motion Detection: This is enabled by default. Click the checkbox to disable.
Handling: Here you can define what will happen when the camera you've selected
detects motion. You can trigger additional cameras to start recording, you can adjust
your arming schedule, send alerts to the SwannView Plus software and to send an
email.
26/08/2014 Tue 11:30:15
Camera1
Sensitivity:
between L (low) and H (high). The closer to H the slider is set, the more sensitive the
motion detection will be.
Full Screen:
Clear:
This will clear the entire area.
Use the "Copy" function to apply these settings to the other cameras.
Don't forget to click "Apply" to save settings.
The sensitivity setting is controlled by a slider, allowing you to set a value
This will select the entire area for motion detection.
33