Sony XDS-PD2000 (J) Installation Manual page 19

11. Check that the two intermediate rails attached
to the rack are parallel.
12. To fi x the two outer rails to the rack, fully
tighten the eight screws in step 8.
Mounting in rack
c
Be sure to carry the unit by the two persons or
more.
13. Slide each ball retainer of intermediate rails
on both sides (left and right) in the direction
of the arrow.
14. Draw the right and left intermediate rails to
the lock position.
15. Grasp the handles of the rack angles while
holding the unit from the bottom, insert the
inner rails into the intermediate rails, and then
push them slowly as far as it will go.
c
Be careful not to catch your fi nger or hand in
rack mount rail.
n
The intermediate rails locked in step 14 are
pushed by the inner rails and unlocked auto-
matically.
XDS-PD2000/PD1000
A A
Intermediate rail Intermediate rail
A' A'
Width : A = A' = 426 mm Width : A = A' = 426 mm
Ball retainer Ball retainer
Stoppers Stoppers
Handle Handle
of the rack angle of the rack angle
Handle of the rack angle Handle of the rack angle
Intermediate rail Intermediate rail
Intermediate Intermediate
rail rail
Inner rail Inner rail
1-11 (E)