Sony XDS-PD2000 (J) Installation Manual page 17

Attaching the rack angles (handles)
5. Attach the two rack angles to both sides (left
and right) of the unit with the four screws.
Tightening torque:
138 x 10
N.m {14 kgf.cm}
-2
Loosely attaching the rail brackets
6. Slide the intermediate rail as shown in the
fi gure, and then loosely attach the rear rail
bracket to the outer rail with the two nuts
with washers and the two screws supplied
with the rail bracket.
7. Slide the ball retainer in the direction of the
arrow, and then loosely attach the front rail
bracket to the outer rail with the two nuts
with washers and the two screws supplied
with the rail bracket.
XDS-PD2000/PD1000
B4 x 10 B4 x 10
Rack angle Rack angle
Screw holes Screw holes
in the handle in the handle
Nuts with washers Nuts with washers
(Supplied with the rail bracket) (Supplied with the rail bracket)
Rail bracket Rail bracket
Outer rail Outer rail
Intermediate rail Intermediate rail
Nuts with washers Nuts with washers
(Supplied with the rail bracket) (Supplied with the rail bracket)
Rail bracket Rail bracket
B4 x 12 B4 x 12
(Supplied with the rail bracket) (Supplied with the rail bracket)
B4 x 10 B4 x 10
Rack angle Rack angle
B4 x 12 B4 x 12
(Supplied with the rail bracket) (Supplied with the rail bracket)
Outer rail Outer rail
Intermediate rail Intermediate rail
Ball retainer Ball retainer
1-9 (E)