Suzuki 2010 SX4 Sedan Owner's Manual page 97

CAUTION
To help prevent damage to the wind-
shield wiper and washer system
components, you should take the fol-
lowing precautions:
• Do not continue to hold in the lever
when there is no windshield
washer fluid being sprayed or the
washer motor can be damaged.
• Do not attempt to remove dirt from
a dry windshield with the wipers or
you can damage the windshield
and the wiper blades. Always wet
the windshield with washer fluid
before operating the wipers.
• Clear ice or packed snow from the
wiper blades before using the wip-
ers.
• Check the washer fluid level regu-
larly. Check it often when the
weather is bad.
• Only fill the washer fluid reservoir
3/4 full during cold weather to allow
room for expansion if the tempera-
ture falls low enough to freeze the
solution.
Rear Window Wiper/Washer Switch
(if equipped)
EXAMPLE
Washer
Wiper
Intermittent wiper
To turn the rear wiper on, twist the rear
wiper switch on the end of the lever for-
ward to the "ON" position. If your vehicle is
equipped the "INT" position, the rear wiper
operates intermittently when you twist the
switch forward to the "INT" position. To turn
the rear wiper off, twist the switch rearward
to the "OFF" position.
To spray window washer fluid, twist the
switch rearward from the "OFF" position, or
twist the switch forward from the "ON" posi-
tion. The rear wiper will turn on automati-
cally while spraying the window washer
fluid.
BEFORE DRIVING
CAUTION
Clear ice or snow from the rear win-
dow and rear wiper blade before
using the rear wiper. Accumulated ice
or snow could prevent the wiper
blade from moving, causing damage
to the wiper motor.
63J304
2-80
80J23-03E