Dive Parameter Settings [1 Set Dive]; Settings And Safety Stop / Deep Stop [1Adj Mode] - Suunto VYTEC DS Instruction Manual

Fig. 4.23. Setting
Altitude adjustment.
Press scroll buttons to
change altitude mode.
Fig. 4.24 Setting
Personal adjustment.
Press scroll buttons to
change personal mode.
Fig. 4.25 Setting RGBM
adjustment. Press scroll
buttons to change setting.
52
4.3.1. Dive Parameter Settings
[1 SET DIVE]
To enter the Dive Parameter Setting Mode
select MODE- 3 SET- 1 SET DIVE. The Dive
Parameter Setting mode has two to four op-
tions depending on the dive computer mode.
In Gauge mode there are two options, in Air
mode three options and in Nitrox mode four
options.
4.3.1.1 Altitude Adjustment,
Personal Adjustment, RGBM Set-
tings and Safety Stop/ Deep Stop
[1 AdJ MODE]
The current Altitude and Personal Adjustment
modes are shown when diving and at the sur-
face. If the mode does not match the altitude
or personal conditions (see section 3.8. "High
Altitude Dives and Personal Adjustment"), it
is imperative that you enter the correct selec-
tion before diving. Use the Altitude Adjustment
to select the correct altitude mode. Use the
Personal Adjustment to add an extra level of
conservatism.
For certain divers and diving conditions you
may want to set attenuated RGBM mode When
this selection is made it is indicated with a con-
tinuously displayed Diver Attention Symbol.
The options are full RGBM effects (RGB100),
and attenuated RGBM (RGB50).
The deepstop setting allows the user to choose
between traditional safety stops or deep stops.
If deep stops are set to OFF, traditional safety
stop calculation is used. If set to ON itera-
tive Deepstops will be prompted instead. The
length of the individual deepstops can be set
to 1 or 2 minutes.
To enter the Altitude Adjustment, Personal Ad-
justment and RGBM effect Setting mode, se-
lect MODE- 3 SET- 1 SET DIVE- 1 AdJ MODE.