Connecting Suunto Cobra3 To A Regulator; Dive Mode Settings; Setting The Depth Alarm; Setting The Dive-Time Alarm - Suunto Cobra3 None User Manual

Suunto cobra3 user's guide

Hide thumbs Also See for Cobra3 None:

Table of Contents

5.7.1. Connecting Suunto Cobra3 to a regulator

When purchasing the Suunto Cobra3, we strongly recommend that you have your Suunto

representative attach it to the first stage of your regulator.

However, if you decide to attach it yourself, follow the steps outlined below:

Remove the high pressure (HP) port plug on the first stage of your regulator using an

appropriate tool.

Thread the high pressure hose of the Suunto Cobra3 into the HP port of your regulator

with your fingers. Tighten the hose fitting with a 16 mm (5/8'') wrench. DO NOT

OVERTIGHTEN!

Attach the regulator to the scuba cylinder and slowly open the valve. Check for leaks

by submerging the regulator first stage in water. If leaks are detected, check the

condition of the O-ring and sealing surfaces.

Suunto Cobra3 has several user-definable functions, as well as depth and time-related

alarms that you can set according to your personal preferences. The DIVE mode settings

are dependent on the dive submode chosen (AIR, NITROX, GAUGE), so that, for example,

nitrox settings are only available in the NITROX submode.

The following figure shows how to enter the DIVE mode settings menu.

NOTE

You can set a depth alarm in the dive computer.

The depth alarm is factory-set to 30 m/100 ft, but you can adjust it according to your

personal preference, or switch it off altogether. The depth range can be set from 3 m to

100 m/9 ft to 328 ft.

The Suunto Cobra3 has a dive-time alarm setting which, when activated, can be used for

several purposes to add to your diving safety.

Some settings cannot be changed until 5 minutes has elapsed after

the dive.

USE UP AND DOWN BUTTONS TO

TOGGLE BETWEEN DIVE SETTINGS

ADJUST WITH UP AND

DOWN BUTTONS. ACCEPT

WITH SELECT BUTTON.

Table of Contents