Push Buttons - Suunto VYTEC DS Instruction Manual

The timekeeping display is the default display
of the instrument (Fig. 2.1.). If a button is not
pressed within 5 minutes, the dive com puter
beeps and returns to the timekeeping display
automatically (except in Diving and Simula-
tion modes). The timekeeping display shuts
off after two hours, but pressing the PLAN or
TIME button activates it.
Making the Vytec personal
For best use of the Vytec take some time and
make it YOUR computer.
Set the correct time and date. Read this manual.
Set dive alarms and make all the other settings
listed in the introduction in this manual. Install
the Vytec in your console or fi t it on your wrist.
If the Vytec is to be used with the optional wire-
less pressure transmitter install it and enable
the pressure transmission in the Vytec's set-
tings. Try the pressure transmission.
Use the dive simulator for getting to know the
dive display
All this so you know your computer and have
it set up as you want it before getting into the
water.

2.2. PUSH BUTTONS

The dive computer has easy-to-use push
buttons and an advisory display, which guides
the user. The SMART (MODE) button is the
key to the system. The two scroll buttons,
PLAN and TIME, are used for scrolling up
and down the menus and to show the alterna-
tive displays. The dive computer is controlled
with these three push buttons as follows
(see Fig. 2.2.).
Fig. 2.1. Time keeping
display. Pressing PLAN
or TIME button activates
display.
Fig. 2.2. Push buttons
of the dive computer.
Fig 2.3. Depth sensor
(A), water/data transfer
contacts (B).
11