Parameter List - Siemens SINAMICS V20 Series Operating Instructions Manual

Can be changed
Inverter state in which the parameter is changeable. Three states are possible:
● Commissioning: C(1)
● Run: U
● Ready to run: T
This indicates when the parameter can be changed. One, two or all three states may be
specified. If all three states are specified, this means that it is possible to change this
parameter setting in all three inverter states. C(1) shows, that the parameter is only
changeable when P0010 = 1 (quick commissioning).
7.2

Parameter list

Parameter Function
r0002 Inverter state
Displays actual inverter state.
0
1
2
3
4
5
6
P0003 User access level
Defines user access level to parameter sets.
0
1
2
3
4
P0004 Parameter filter
Filters parameters according to functionality to enable a more focused approach to commissioning.
0
2
3
5
7
8
10
12
13
19
20
SINAMICS V20 Inverter
Operating Instructions, 07/2012, A5E03728167
Range Factory
default
- -
Commissioning mode (P0010 ≠ 0)
Inverter ready
Inverter fault active
Inverter starting (visible only while pre-charging DC link)
Inverter running
Stopping (ramping down)
Inverter inhibited
0 - 4 1
User defined parameter list - see P0013 for details on use
Standard: Allows access into most frequently used parameters
Extended: Allows extended access, for example, to inverter I/O functions
Expert: For expert use only
Service: Only for use by authorized service, password protected
0 - 22 0
All parameters
Inverter
Motor
Technology application / units
Commands, binary I/O
Analog input and analog output
Setpoint channel / RFG
Inverter features
Motor control
Motor identification
Communication
Can be Scaling
changed
- -
U, T -
U, T -
Parameter list
7.2 Parameter list
Data Data Acc.
set type Level
- U16 2
- U16 1
- U16 1
121