IBM 3746-900 Installation And Maintenance Manual page 86

MAP (continued)
3-6
3745-XXA 3-6 3746-9X0: 6578 SPIM
Table 3-1 (Page 5 of 12). POST Errors
Symptom / Error
1106
Serial option cannot be turned off.
1107
1110
Register test failed.
1116
Interrupt error.
1117
Failed baud rate test.
1162
Serial port configuration error.
11XX
Not listed previously
1201
1202, 1206, 1208, 1209, 12XX
1207
13XX
1402
Printer not ready.
1403
No-paper error, or interrupt failure.
1404
System board timeout failure.
1405
Parallel adapter error.
1406
Presence test error.
14XX
Not listed above.
Check printer before replacing system
board.
15XX
1692
Boot sequence error.
16XX
1762
Hard disk drive configuration error.
FRU to replace / Action to take
1. Run Enhanced Diagnostics.
2. System Board
1. Serial Device Cable
2. System Board
1. Run Enhanced Diagnostics.
2. System Board
Run Enhanced Diagnostics.
Run Enhanced Diagnostics.
1. Run Configuration.
2. Serial Adapter (if installed)
3. System Board
System Board
1. System Board
2. Any Serial Device
1. Dual Async Adapter/A
2. System Board
3. Any Serial Device
1. Communications Cable
2. Dual Async Adapter/A
Game Adapter
Information only
Information only
Run Enhanced Diagnostics.
Run Enhanced Diagnostics.
Run Enhanced Diagnostics.
1. See "Printer" on page 3-19.
2. System Board
SDLC Adapter
Run FDISK to ensure at least one
active partition is set active.
36/38 Workstation Adapter
Run Configuration/Setup Utility (see
"Service Processor Configuration /
Setup Utility" on page H-8).