IBM 3746-900 Installation And Maintenance Manual page 134

4-16
3745-XXA 4-16 3746-9X0: 6578 SPIM
Diagnostic Error Code
014-195-XXX
Parallel port Test aborted by user
014-196-XXX
Parallel port test halt, error threshold
exceeded
014-197-XXX
Parallel port test warning
014-198-XXX
Parallel port test aborted
014-199-XXX
Parallel port test failed, cause unknown
014-2XX-XXX
014-3XX-XXX
Parallel port failure
015-000-XXX
USB port Interface Test Passed
015-001-XXX
USB port Presence
015-002-XXX
USB port Timeout
015-015-XXX
USB port External Loopback failure
015-027-XXX
USB port Configuration/Setup error
015-032-XXX
USB port Device Controller failure
015-034-XXX
USB port buffer allocation failure
015-035-XXX
USB port Reset condition detected
015-036-XXX
USB port Register error
015-040-XXX
USB port IRQ failure
FRU to replace/action to take
1. Information
2. Restart the test, if you need to.
1. Press F3 to review the log file. See
"Viewing the Test Log" on
page 4-8.
2. Restart the test to reset the log file.
1. Make sure that the component that
is called out is enabled or
connected.
2. Rerun the test.
3. Component that is called out in
warning statement
4. Component under test
1. If a component is called out, make
sure that it is enabled or
connected.
2. Flash the system and retest.
3. Go to "Undetermined Problems" on
page 3-22.
1. Go to "Undetermined Problems" on
page 3-22.
2. Flash the system and retest.
3. Replace component under function
test.
1. External parallel device
2. System board
No action
1. Remove USB Devices and retest.
2. System board
1. Remove USB Devices and retest.
2. System board
1. Remove USB Devices and retest.
2. System board
1. Flash the system.
2. System board
System board
1. Reboot the system.
2. Flash the system.
3. Run memory test.
4. System board
1. Remove USB Devices and retest.
2. System board
System board
1. Run setup and check for conflicts.
2. Flash the system.
3. System board