IBM 3746-900 Installation And Maintenance Manual page 82

MAP (continued)
001 (continued)
1. Power-off the system.
2. Check all cables and power cords.
3. Make sure there are no diskettes in the drives.
4. Set all display controls to the middle position.
5. Power-on the system.
Note: If you get a POST error code, press Pause (while the error code is on the
panel). Write down any error codes that are displayed, then press F1 to continue.
Did you receive a POST error code?
Yes No
003
Check your FIRST POST ERROR with Table 3-1.
3-2
3745-XXA 3-2 3746-9X0: 6578 SPIM
002
Go to Step 006 on page 3-13.
Table 3-1 (Page 1 of 12). POST Errors
Symptom / Error
000
SCSI Adapter not enabled.
02X
08X
Check SCSI terminator installation.
101
System board Interrupt failure.
102
System board timer error.
106
110
System board memory parity error.
111
I/O channel parity error.
114
Adapter ROM error.
129
Internal cache test error.
151
Real-time clock failure.
FRU to replace / Action to take
Verify adapter device and bus master
fields are enabled in PCI configuration
program. Refer to the documentation
shipped with computer.
SCSI Adapter
1. SCSI Cable
2. SCSI Terminator
3. SCSI Device
4. SCSI Adapter
System Board
System Board
System Board
1. Memory Module
2. System Board
1. Reseat adapters
2. Any Adapter
3. System Board
1. Adapter Module
2. System Board
1.Processor
2. L2 Cache Memory
3. System Board
System Board