IBM 3746-900 Installation And Maintenance Manual page 132

4-14
3745-XXA 4-14 3746-9X0: 6578 SPIM
Diagnostic Error Code
006-000-XXX
Diskette interface Test Passed
006-0XX-XXX
Diskette interface error
006-195-XXX
Diskette interface Test aborted by user
006-196-XXX
Diskette interface test halt, error threshold
exceeded
006-197-XXX
Diskette interface test warning
006-198-XXX
Diskette interface test aborted
006-199-XXX
Diskette interface test failed, cause
unknown
006-25X-XXX
Diskette interface Error
011-000-XXX
Serial port Interface Test Passed
011-001-XXX
Serial port Presence
011-002-XXX
011-003-XXX
Serial port Timeout/Parity error
011-013-XXX
011-014-XXX
Serial port Control Signal/Loopback test
failure
011-015-XXX
Serial port External Loopback failure
011-027-XXX
Serial port Configuration/Setup error
FRU to replace/action to take
No action
1. Diskette drive Cable
2. Diskette drive
3. System board
1. Information
2. Restart the test, if you need to.
1. Press F3 to review the log file. See
"Viewing the Test Log" on
page 4-8.
2. Restart the test to reset the log file.
1. Make sure that the component that
is called out is enabled or
connected.
2. Rerun the test.
3. Component that is called out in
warning statement
4. Component under test
1. If a component is called out, make
sure that it is enabled or
connected.
2. Flash the system and retest.
3. Go to "Undetermined Problems" on
page 3-22.
1. Go to "Undetermined Problems" on
page 3-22.
2. Flash the system and retest.
3. Replace component under function
test.
1. Diskette drive Cable
2. Diskette drive
3. System board
No action
1. Remove external serial device, if
present.
2. Run setup, enable port.
3. System board
System board
System board
1. Wrap plug
2. System board
1. Run Setup, enable port.
2. Flash the system.
3. System board