General information
2.2 Configuring the Web server
Activate web server on this module
The web server is disabled in the default setting of a configured CPU. Proceed as follows to
enable the Web server:
1. Open the "Devices & Networks" view by double-clicking in the project tree in STEP 7.
2. Select the desired CPU in the device, network or topology view.
3. Navigate to the "Web server" area in the Inspector window properties, "General" tab.
4. Select the "Activate web server on this module" check box.
The following note is output:
Figure 2-2
Note
When projects from deliveries are applied in which the Web server was already activated
and configured on the module, this security note is not shown.
20
Security note upon activation of the Web server in STEP 7
Function Manual, 11/2019, A5E03484625-AG
Web server