Table of Contents
Advertisement
5.3.4 INSTALLATION PARAMETERS
Key sequence to access the installation menu
-
During the modification of the parameters, the symbol
-
Use the MODE key to change various parameters.
-
With the buttons
-
To memorise the values press the button "SET". The symbol
appear on the screen for a few seconds to show that the data has been saved.
DESCR
PARAMETER
MENU
DISPLAY
TIP O
Pump type
it is possible to modify the values.
NAME
Identifies whether the pump is part of a unit or whether it
is a single pump, possible values:
NCON: pump not configured (factory setting)
SING: single pump
PRI: primary or master pump for a unit
SEC: secondary or slave pump for a unit
Page 14 of 30
Last button pressed for 10 seconds
on the display lights up.
DESCRIPTION
14 - GB -
disappears. The words "REC" will
DEFAULT
MIN
SING
N.A.
MAX
N.A.
41
Advertisement
Table of Contents
