Error Table - Pentair Pool Products Nocchi CPS 10 Use And Maintenance Manual

6.4 ERROR TABLE

MESS
DISPLAY
E00
No event
Generic fault (in
E01
memory)
Temporary external
error
E02
Definitive external
error
E03
Communication
E04
error
E05 Over voltage error
Under voltage error
E06
temporary
Under voltage error
E07
definitive
DESCRIPTION
The error log appears when no
errors have been signalled
This error occurs in the presence
of:
x
Internal module error
x
Overheating of the power
module
x
Pump failure
An external error occurs when
there is a problem with the power
module. The module will not be
operative during an EXTERNAL
ERROR.
The definitive external
condition is indicated after the
temporary error condition
repeated 5 times.
This error condition occurs when
the control board
communication with the power part.
This alarm condition closes the J3
contact on the power board for
possible external signals (alarm
light, siren, etc.).
This error occurs
current absorbed by the module is
greater than triple the nominal
current.
This condition can be caused
when the pump is blocked by
foreign bodies.
This alarm condition closes the J3
contact on the power board for
possible external signals (alarm
light, siren, etc.)
This error condition occurs when
the voltage is 10% less than the
nominal voltage (230V).
This alarm condition closes the J3
contact on the power board for
possible external signals (alarm
light, siren, etc.)
This error occurs
temporary under voltage condition
is repeated 5 times.
Page 20 of 30
20 - GB -
-
Press the START/STOP button to
attempt to exit this condition. In
case of a persistent error, contact
technical support.
In this case, the module will
attempt
functioning after 5 minutes and
will repeat this procedure up to
five times.
Press the START/STOP button to
attempt to exit these conditions.
Please contact technical support
of the error persists.
error Press the START/STOP button to
attempt to exit this condition.
is Please contact technical support
of the error persists.
Cut the power off and wait until
cannot
the LINE Led switches off and
after which turn power back on.
If the error condition occurs again,
contact your nearest assistance
centre.
when the
Cut off the power supply and wait
for the LINE Led to switch off.
Check the pump freely rotates
and if necessary remove foreign
bodies
functioning.
Turn power back on.
If the error persists, contact your
nearest assistance centre.
Press the button START/STOP or
cut the power off and wait until the
LINE Led switches off and after
which restart the system.
If the error occurs again, contact
your nearest assistance centre.
when the
ACTION
to restart normal
that block correct
47