Ricoh MP 7503SP Field Service Manual page 219

13. Set the screws in the side of the tray, and then set the keyholes of the table extension [A] over the
screws ( x 2) (M4 x 8).
14. With the extension slightly loose against the edge of the tray, align the end of the table extension
with the edge of the finisher.
15. Tighten the screws.
16. Skip this step if you are going to install the Cover Interposer Tray. (You will attach the cushion later
at another location during the Cover Interposer installation.)
-or-
If you are not going to install the Cover Interposer Tray, attach the cushion [A] to the right side of
the upper cover.
17. Skip this step if you are going to install the Cover Interposer Tray. (You will attach the entrance
guide plate later at another location during the Cover Interposer installation.)
-or-
Finisher SR4080 (D610)
217