Downloading Stamp Data - Ricoh MP 7503SP Field Service Manual

After approximately 10 seconds, the initial screen opens in English.
6. Touch [Opepanel.DOM].
7. Touch [UpDate(#)] to start the update.
While the data downloads, the operation panel goes off.
The LED on the [Start] key flashes red at 1/2 second intervals for approximately 6 minutes.
When the update is completed, the [Start] key starts to flash at 1-second intervals.
8. Turn the copier main power switch off, remove the SD card, then turn the copier on again.

Downloading Stamp Data

After you replace or format the HDD, download the stamp data from the controller firmware to the hard
disk.
1. Go into the SP mode.
2. Select SP5853 then press "Execute".
3. Obey the instructions on the screen to complete the procedure.
Uploading/Downloading NVRAM Data
Uploading Content of NVRAM to an SD card
Do this procedure to upload SP code settings from NVRAM to an SD card.
• Always upload this data to an SD card before you replace the NVRAM.
1. Before you turn the machine off, do SP5990 001 (SMC Print). This gives you a record of the
NVRAM settings if the upload fails.
2. Turn the copier main power switch off.
3. Put the SD card into slot 2, then turn the copier on.
4. Do SP5824 001 (NVRAM Data Upload) then push the "Execute" key
When uploading is completed, a file is coped to the NVRAM folder on the SD card. The file is
saved to this path and filename:
NVRAM\<serial number>.NV
5. To prevent an error during the download, write the serial number of the machine on the SD card.
• This is necessary because NVRAM data from more than one machine can be uploaded to the
same SD card.
Firmware Update
1191