Installing The Ethernet Switch; S8800 Ethernet Port Assignments - Avaya S8800 Manual

Installing and connecting peripheral equipment
1. Place the UPS at the bottom of rack.
2. Connect one end of power-cord connector of the S8800 Server power supply to the
3. Connect the power cord of the UPS to a properly grounded electrical outlet.

Installing the Ethernet switch

1. Place the Ethernet switch on the rack.
2. Connect one end of the power cord to the Ethernet switch and the other end to an
3. Use a straight-CAT 5 cable to connect the appropriate Ethernet port on the S8800

S8800 Ethernet port assignments

The following ethernet port assignments are the physical assignments on the server and the respective
functionality. All Communication Manager templates use only eth0 as the interface to configure the
server except for the Duplex main/survivable core template that uses eth0 and eth1 software interfaces
to configure the server. eth1 is used for configuring the duplication parameters.
Ethernet
1
28 Installing the Avaya S8800 Server for Avaya Aura
UPS.
Important:
Avaya recommends that the SAL gateway use a separate UPS than the UPS
used to supply power to the S8800 Server. It is also recommended to use
separate UPS units for each S8800 Server in a duplex system.
outlet on UPS.
Server to the Ethernet switch.
Duplex main/ simplex
survivable main/
core survivable
core
Corporate Corporate
LAN / LAN /
processor processor
Ethernet Ethernet
Embeded simplex
main survivabl
(Federal e remote
market
only)
Corporate Corporate
LAN / LAN /
processor processor
Ethernet Ethernet
™
Communication Manager
embeded NIC
survivable Locatio
remote n
Corporate Located
LAN / on
processor motherb
Ethernet oard
June 2010