Low Battery Status; Apple Homekit Wi-Fi Accessory Configuration; Dealer Info And Language Selection; Warning Screen - Lennox iComfort E30 Installation And Setup Manual

B - s
oot up CrEEn
When power is applied to the system, the HD Display will display a welcome screen.
If there is an issue with communication between any component attached to the
thermostat, a critical alert message will appear on the screen. The alert message
will provide detail information concerning the possible cause. Once the issue is
corrected and power is restored to the system the first screen in the initial setup
sequence will appear.
Below is an example of a communication error message.
IComfort cannot communicate with the equipment
IComfort is unable to connect to the Smart Hub device
If problem persists, please contact your iComfort dealer at
1-800-9-LENNOX or visit www.lennox.com/support
Figure 15. Communication Error Message
l B s
oW attEry tatus
If a critical low battery screen is displayed, the system will automatically start
charging the HD Display internal battery. On the screen the word "charging" will
appear. Once "charging" disappears (typically 3 to 10 minutes) then the display will
automatically start-up.
a h K W -F a
pplE omE it i i CCEssory
A pop-up screen will appears providing instructions on how to connect the
thermostat to the home Wi-Fi network using an Apple IOS device. If you wish to
use this method to configure the unit for Wi-Fi and Apple HomeKit, then refer to the
provided user guide for additional instructions.
Otherwise, select cancel to proceed with the thermostat commissioning procedures.
There is an option to perform this task later on at the homeowners convenience.
NOTE: This procedure can only be accomplished using the homeowner's Apple
mobile IOS device.
alert
1-800-555-8888
For additional support, contact Lennox at
C
onFiguration
Figure 16. IOS Wi-Fi Accessory Configuration
D i l
EalEr nFo anD anguagE
The first screen in the commissioning sequence is the dealer information screen and
language selection tool. Supported languages are English, French and Spanish.
The drop-down selection tool is located in the upper right-hand corner of the screen.
Dealer ID and/or phone number can be added. Once the system is connected to the
Internet, the remaining information will be populated automatically by the Lennox
server based on the dealer ID or phone number entered. All information can be
entered manually if desired however.
Information that can be manually entered is name, email website, dealer address
which includes address 1, address 2, city, state and zip/postal code. Once completed
touch continue.
W s
arning CrEEn
If either the Dealer ID or phone number is NOT provided, a warning screen will
appear. The warning screen will provide information on the limitation imposed on
the system if this information is not provided. Touch no to return to the previous
screen to complete the information requested or touch yes to continue.
g i
EnEral nFormation
On this screen general information needs to be verified or changed. Touch any item
to change its contents. A pop-up screen will appear that will allow the information to
be added or changed.
Information required:
1. Select desired language (ENGLISH, FRANÇAIS or ESPAÑOL).
2. Select country / region.
22
s
ElECtion