Additional Safety Instructions For Working With Wire Brushes; Practical Tips; Assembly; Mount Handgrip - Parkside PWS 125 C3 Instruction Manual

G B
the fastening cords verse defrost
oder. Loose, revolving attachment
strings can capture your fingers or be-
come entangled in the workpiece.
Additional safety instructions
for working with wire brushes
Special safety instructions for
working with wire brushes:
• Be aware that the wire brushes
also lose wire pieces during typi-
cal use. Do not overload the wi-
res by pressing down too hard.
Flying wire pieces can very easily penet-
rate thin clothing and/or your skin.
• If a protective hood is recom-
mended, do not allow the wire
brushes and the protective hood
to touch each other. The diameter
of plate and cup brushes can enlarge if
too much pressure and centrifugal force
is exerted.

Practical tips

Scrubbing wheels:
Never use a cutting wheel for
scrubbing !
The device must only be
operated with the protecti-
ve hood mounted when the
rough grinding wheel is used.
Exert only moderate pressure on the work-
piece. Move the device evenly back and
forth.
A working angle of 30° to 40° achieves
the best results for scrub grinding.
1 4
Cutting disc:
Never use a scrubbing wheel
for cutting !
The device must only be
operated with the protective
hood mounted when the cut-
ting disc is used.
Only certified, fibre-reinforced cutting or
grinding discs may be used.
In general, work with small scrubs. Exert
only moderate pressure on the workpiece.
Always work in the counter-direction. This
ensures that the device is not pushed out of
the cut through lack of control.

Assembly

Caution! Risk of injury!
- Ensure that you have sufficient
space in which to work, and that
you do not endanger other people.
- All hoods and protective devices
must be assembled properly be-
fore commissioning.
- Disconnect the mains plug be-
fore changing the setting on the
device

Mount handgrip

The device must only be
operated with the handgrip
mounted.
Depending on the method of working,
tighten the handgrip (1) on to the handgrip
thread on the left (8), right (see illustration
) or top (2) of the device.