Setting The Origins; How To Set The Origins - Roland Aproll MDX-540S User Manual

5-5 Setting the Origins

How to Set the Origins

This sets the origins at the present tool location. You make the settings separately for the X, Y, and Z axes. This operation
cannot be performed during a cutting operation or while operation is paused.
For related items, P. 62 "4-3 Starting Cutting (RML-1 Mode)" + P. 67 "4-4 Starting Cutting (NC-code Mode)"
Procedure



86
Chapter 5 Handy Panel
*READY
USER(RML1)
> X 100 .000
Y 50 .000
Z -30.000 S 0
[ ]
RATE x500 100%-XYZ
100%-S
USER(RML1) *READY
> X 100 .000
Y 50 .000
Z -30.000 S 0
[ ]
RATE x500 100%-XYZ
100%-S
*READY
USER(RML1)
> X 0 .000
Y 50 .000
Z -30.000 S 0
[ ]
RATE x500 100%-XYZ
100%-S
Move the tool to the location you
want to make the origin.
Press the [COORD. SYSTEM] key
several times to select the coordinate
system.
Use the axis-selection keys to select
the axis for setting the origin.
Hold down the [ORIGIN] key until an
audible beep is sounded.