Fujitsu PRIMERGY TX150 S6 Operating Manual page 46

Mounting the rack model
To install the left-hand rail in the PRIMECENTER/DataCenter Rack, the support
bracket supplied must first be mounted flush on the rear left support upright.
I
For better orientation the height units are marked on the support uprights
(PRIMECENTER Rack only).
Figure 6: Fitting the support bracket
Ê Place the support bracket at the appropriate height on the left rear support
upright by inserting the positioning nub (n) in the corresponding hole of the
support upright.
Ê Secure the bracket with two screws inc. plug washers.
No nuts are required to secure the support systems as the fixing holes on the
rails are threaded.
46 Operating Manual
Hardware installation
TX150 S6