Fujitsu PRIMERGY TX150 S6 Operating Manual page 11

Preface
TPM (optional)
The system board is optional equipped with a TPM (Trusted Platform Module)
by the manufacturer. This module enables programs from third party manufac-
turers to store key information (e.g. drive encryption using Windows Bitlocker
Drive Encryption).
The TPM is activated via the BIOS system (for more information, refer to the
Fujitsu Siemens Computers BIOS manual).
V
CAUTION!
– When using the TPM, note the program descriptions provided by the
third party manufacturers.
– You must also create a backup of the TPM content. To do this, follow
the third party manufacturer's instructions. Without this backup, if the
TPM or the system board is faulty you will not be able to access your
data.
– If a failure occurs, please inform your service about the TPM
activation before it takes any action, and be prepared to provide them
with your backup copies of the TPM content.
Hard disk drives
The server is shipped with one of the following drive cages:
– For up to four 3.5-inch SAS/SATA hard disk drives:
Up to four SAS/SATA HDD modules can be used in the drive cage. Each
HDD module can accommodate an SAS/SATA hard disk drive with a
maximum height of 1 inch. The module is connected to the SAS/SATA
backplane wirelessly. This allows HDD modules to be plugged in or pulled
out easily.
A hard disk drive extension box can be installed optionally (with a maximum
of two SAS HDD modules).
SATA hard disk drives are controlled by the onboard SATA controller. An
additional SAScontroller must be installed to control SAS hard disk drives.
Mixed configurations of SAS and SATA HHDmodules in one drive cage are
not supported.
TX150 S6
Operating Manual
Features
11