Table of Contents
Advertisement
Setting Snapshot Attributes
Except for the GPI output attributes, you can apply attributes to a snapshot
when saving or recalling the snapshot. In the REGISTER menu you can set
these attributes separately for each sub-register.
Since the sub-registers within the "USER" group are saved and recalled
together, it is not possible to make separate attribute settings for them, except
that this is possible when using the REGISTER menu.
In the REGISTER menu, you can apply GPI output attributes, but in this case
the attributes apply to the whole register, and it is not possible to make
separate settings for sub-registers.
Setting attributes
To set an attribute other than a GPI output attribute, use the following
procedure.
1
In the REGISTER menu, select item 3 (ATTRIB EDIT).
The ATTRIB EDIT menu appears, and a cursor appears over the list of
registers. The function key indications in the ATTRIB EDIT menu
depend on where the cursor lies in the list of registers.
The list of registers is divided into three pages: page 1/3 shows
information relating to the M/E-1, M/E-2, M/E-3 and P/P DSK sub-
registers, page 2/3 shows information relating to the "USER" group, and
page 3/3 shows information relating to the DME.
To switch among the three pages, use the cursor movement buttons (?
or /) to move the cursor to the right or left edge of the current page,
then press the cursor movement button once more.
2
Use the cursor movement buttons (> . ? /) to align the cursor with
the sub-register for which you wish to make the setting.
The function key indications change according to the sub-register
selected with the cursor.
(Continued)
9-13
Chapter 9 Registers
Advertisement
Table of Contents
