Choice Of Gear; Set The Direction Of Rotation; Torque Setting; Tool Change - Parkside PBSA 20-Li A1 Translation Of The Original Instructions

Removing the battery pack:
• Push the release button (
and pull the battery pack
(11) out towards the front of
the device.

Choice of gear

Slide the gear selector (
corresponding to a low or high torque
selection.
A gear change may only be per-
formed in standstill mode!

Set the direction of rotation

You can select the direction of rotation
with the direction switch (clockwise and
anticlockwise direction) and secure the de-
vice against accidental start up.
1. Wait for the device to shut-down.
2. Clockwise direction:
Press direction switch (6) to
the right.
3. Anticlockwise direction:
Press direction switch (6)
to the left.
4. Switch lock: Bring direction
switch to neutral position.
The direction changed may only be
performed in standstill mode.

Torque setting

You can preset the maximum torque by ro-
tating the torque adjustment ring (
25 torque settings + 1 drill setting are
provided.
11a)
4) to 1 or 2,
3).
1. Turn the adjusting ring (
the desired torque:
Step 1 -->
Step -->
Screws:
Drilling:
2. Start with a lower torque step and in-
crease according to requirement.
Torque adjustment should only be
performed in standstill mode.
Reaching the preset torque limit pro-
duces a noticeable rasping sound.
This sound is caused by the slip clutch.

Tool change

1. Rotate the keyless chuck (2) coun-
ter-clockwise, until the drill chuck
aperture (11) is large enough to
accommodate the tool.
2. Push the tool as far as possible into
the keyless chuck (2).
3. Rotate the chuck clockwise to
clamp the tool firmly.
4. To remove the tool again, rotate the
keyless chuck (2) and pull out the tool.

Switching on/off

By using the on/off switch (
progressively control the speed. The longer
you push the on-off button, the higher the
speed.
1. Press the on/off switch (5) to start
the device. The LED work light
(10) lights up during operation.
2. To turn it off, release the on/off
switch (5).
When you move the direction
switch (6) to the middle position,
GB
3) to select
lowest torque,
highest torque.
Steps 1 - 19
Step .
5) you can
IE
21