Charging The Battery; Removing/Inserting The Battery - Parkside PBSA 20-Li A1 Translation Of The Original Instructions

sult in internal short circuits.
• Do not operate the charg-
er on a combustible sur-
face (e.g. paper, textiles).
Risk of fire due to heating dur-
ing charging.
• If the power cable for this equip-
ment is damaged, it must be
replaced by the manufacturer,
a customer service agent of the
same or a similarly qualified per-
son in order to prevent hazards.
• The battery of the appliance is
not fully charged at the time of
delivery. It therefore needs to be
fully recharged before you use
it for the first time. For the first
recharge cycle we recommend
that you charge the battery for
about one hour. Slot the battery
into the base and plug the bat-
tery charger into a mains outlet.
• When the battery is fully
charged, unplug the charger
from the mains and from the ap-
pliance.
•
Do not use the charger
non-rechargeable batteries.
The device could become dam-
aged.

Charging the battery

Do not expose the battery to
extreme conditions such as
heat or impact. Risk of injury
from escaping electrolytic so-
lution! After eye/skin contact,
rinse the affected areas with
water or a neutraliser and
consult a doctor.
to charge
Charge the battery in a dry
room only. Prior to attach-
ing the charger, check that
the battery's outer surface is
clean and dry. There is a risk
of injury due to electric shock.
• Charge the battery before the first time
of use.
• To recharge the battery, only use a
charger belonging to the Parkside
X 20 V TEAM series.
• If a fully recharged battery lasts for con-
siderably shorter operating times, the
battery is used up and needs to be re-
placed. Only use an OEM spare battery
available from our Customer Service.
• Always take heed of the applicable safety
instructions as well as the environmental
protection regulations and information.
• The warranty excludes all defects
caused by improper handling.
Removing/inserting the
battery
1. To remove the battery from
the device, press the release
button (1) on the battery (4)
and pull the battery out.
2. To insert the battery (4), place it on the
guide track and push it back into the
appliance. It will audibly snap in.
Do not insert the battery
until the appliance is fully
assembled (when delivered,
the battery may already be
inserted). Risk of injury!
GB IE
17