Table of Contents
Advertisement
OPERATION
2. FRONT PANNEL CONTROLS
2-1. POWER ON / OFF
After the connection of power cord and other devices with SVR-1620, Turn the power on.
• Before the power of SVR-1620 is on, check the input power currency in advance and select
the indication of power input (230V=180V~265V, 115V=90V~135VAC)at the rear-side of DVR
• If there is no video signal, the video signal system is set to NTSC. Do not input the PAL type video signal or it may
cause SVR-1620 malfunction. In this case, turn off and on again.
2-2. SCREEN DISPLAY
2-2-1. Multi Display & Full Screen display
a. Multi display
To change a single camera display to the multi camera, press the Multi button.
b. Full screen display
Press the desired camera number button you wish to display on the monitor.
The number of the camera select buttons are used to set the password In the Password Lock function.
16
a. The video signal system (NTSC or PAL) is automatically
detected.
b. Power Failure Recovery
SVR-1620 automatically reverts back to programmed record
parameters upon power restoration.
c. If the power key is protected by password, the power on/off
cannot be executed before input the correct password.
(Refer to the Password Setup in the main menu)
USER'S MANUAL
Advertisement
Table of Contents
