Setup; General Safety Information; Scope Of Delivery; Installing The Mast To The Base - Invacare ISA COMPACT User Manual

Invacare® ISA™

4 Setup

4.1 General safety information

WARNING!
– Check all parts for shipping damage before use.
– In case of damage, do not use the equipment.
Contact your Invacare provider for further
instructions.
WARNING!
Risk of Injury
Improper assembly may cause injury or damage.
– Use only Invacare parts in the assembly of this
patient lift.
– After each assembly, check that all fittings
are properly tightened and all parts have the
correct function
– Do not overtighten the mounting hardware.
This may damage the mounting brackets.
There are no tools required to assemble the patient
lift.
If there are any issues or questions during assembly,
contact your Invacare provider.

4.2 Scope of delivery

The items included in your package depend on the models
and configurations available in your country. See 1.1
Introduction, page 4
Mast / boom assembly (1 piece) — incl.
A
control unit and actuator
B Base with or without actuators (1 piece)
Leg support
C
Foot plate
D
Hand control (1 piece)
E
Mains cable (1 piece)
10
User Manual (1 piece)
Battery (1 or 2 pieces)* – CBJ Care, CBJ1 and
CBJ2 only
Lever for manual leg spreader (1 piece)*
Leg band (1 piece)*
Sling (1 piece)*
* Depends on model and/ or configuration
If the lift is delivered with a sling, refer to the user
manual of the sling for use, application, maintenance
and washing instructions.

4.3 Installing the mast to the base

WARNING!
Risk of injury or Damage
The maximum safe working load stated on the
boom and on the base must be the same.
– Always compare the maximum safe working
load values stated on the base and on the
boom.
1.
Lock both rear castors B and rotate the hand screws
anti-clockwise A to remove them from the base
2.
With the boom pointing in forward direction, lower the
mast C into the support of base D and reinstall the
hand screws A to fix the mast C to the base.
1654371-A