Table of Contents
Advertisement
Troubleshooting
Digital Display
The indoor unit is equipped with a receiver that has a
digital display that provides an error code. Refer to the
table to view the error codes. The error code will replace
the temperature setting displayed on the receiver. If more
than one error has occurred, the codes will alternate so
that all codes are shown.
Error Code
FE
E0
E1
E2
E3
E4
E5
E6
E7
Eb
EC
Ed
EE
A0
D8
U4
F8
Error Code
F0
F1
E2
Figure 28. Receiver/Display
Table 8. Fault Code Display on Indoor Unit Receiver
Description
No address
Mode conflict
Communication error between indoor and main outdoor unit
T0 (Room temperature sensor) malfunction
T2 (Middle of evaporator sensor) malfunction
T2B (Outlet of evaporator sensor) malfunction
T2A (Inlet of evaporator sensor) malfunction
DC fan motor error
EEPROM failure
EXV malfunction
TA (Discharge temperature sensor) malfunction
Outdoor unit Fault
High Water Alarm
Emergency stop
Remote off
MS self-inspection error
MS error
Table 9. Fault Code Display on Controller
Description
Communication/Address error between indoor units and wired controller
Communication/Wiring error between indoor units and wired controller
Controller temperature sensor error
Make note of the code (E1, EE, etc.), then reset the
display by pressing the ON/OFF button on the unit
controller. Press the ON/OFF button a second time
to reapply power to unit. If the code is still displayed,
disconnect and restore power at the unit disconnect
switch or circuit breaker. If the problem was temporary,
the code will not reappear. If the error code reappears
after power has been broken and restored at the
disconnect switch or circuit breaker, call VRF Technical
Support 1-844-438-8731.
23
Advertisement
Table of Contents
