Lennox VOSB Series Installation Instructions Manual page 21

Mounting the Receiver/Display
The VOSB unit receiver/display must be field-connected
and mounted. Mounting slots are available on the bottom
of the electrical control box.
1. Remove receiver from accessories package.
2. Insert the two fixed plastic mounting brackets on the
back of the receiver (Figure 26) into the two slots on
the bottom of the electrical control box (Figure 25) and
slide to secure it.
3. Connect the 10-conductor wire of the receiver to the
unit control board. Pass the wire though the cable
path. See Figure 27.
Fixed plastic
mounting
brackets
Figure 26. Receiver
10-conductor wire
(to unit control board)
Figure 27. Receiver Mounting Location
If it is necessary to position the receiver a distance from the
unit, use the optional extension cable kit V0CTRL93P-1
(cat # 14R84).
Network Address and Commissioning
After the system has been installed, each indoor
unit must be assigned an address as part of the
commissioning procedure.
21
Cable path
Slots
Electrical
control box