Table of Contents
Advertisement
139987-C GI 645 DV and DV MV 6/21
7.6 Optional Firebox Panels
158131 Black Reflective Glass
• Rear Panel - 226461
• Right Side Panel - 226462
• Left Side Panel - 226463
• Side Panel Stand-off (2) -
226643
• Cotton Gloves - 138765
• Retainer Tabs (2) - 224727
• Nuts (2) - 117968
158133 Black Fluted Panels
• Rear Panel - 226694
• Left Side Panel - 226695
• Right Side Panel - 226696
• Baffle Panel - 226697
These instructions apply to all panel kits, except as noted.
Inspect each panel and contact your dealer if any damage is found.
THE PANELS ARE VERY FRAGILE. HANDLE GINGERLY.
BE CAREFUL TO AVOID DAMAGE TO EDGES OR
CORNERS BY CONTACT WITH OTHER PARTS OF THE
GLASS PANEL NOTES:
USE THE COTTON GLOVES PROVIDED TO
HANDLE THE GLASS PANELS AND PREVENT
FINGERPRINT STAINS. SKIN OIL RESIDUE IS
DIFFICULT TO REMOVE FROM THE GLASS
SURFACES.
INSTALL EACH GLASS PANEL ORIENTED WITH
THE TEXTURED SIDE FACING AGAINST THE
FIREBOX
WALLS.\
1. Install the Side Panel Retainer Tabs - Glass Kit
Only
Panel retainer tabs (fig. 7.9) are installed at the upper
front corners of the firebox walls. Hand start the nuts
over the tabs as shown.
2. Install the Rear Panel - all kits
The panel simply rests on the rear burner skirt, flat against
the back of the firebox with the beveled edge (brick and
stone kits) facing up. The side panels will lock the rear
panel in place as they are installed. Fig. 7.10.
3. Install the Side & Baffle Panels
• Brick or Fluted Kits
Set left panel on the burner skirt directly against the
firebox wall.
Place the left edge of the baffle piece on top of panel.
Hold flush to top of firebox and install right panel.
Retainer tabs are not necessary for this installation.
• Glass Kit only (fig. 7.11)
Set the steel Stand-off Plate (B) on the burner skirt
between the wall and the glass Side Panel (C). Orient
each Side Panel, textured side-in, on the burner skirt
against the Stand-off Plate.
20
158132 Traditional Red Brick
• Rear Panel - 226624
• Left Side Panel - 226625
• Right Side Panel - 226626
• Baffle Panel - 226627
158195 Brownstone Brick
• Rear Panel - 226698
• Left Side Panel - 226699
• Right Side Panel - 226700
• Baffle Panel - 226701
Tools Required:
• Pliers or flat screwdriver
• Safety glasses
• Assistant
FIREPLACE.
IMPORTANT!
PARTNAME:
Figure 7.9
Install panel retainer
tabs.
Figure 7.10 Install rear panel. Fluted panel shown.
351617_Rear_Panel
12/18/19
DRAWING DATE:
Fig. 7.11. Glass panel installation.
• Using a 10mm wrench, tighten nuts for retainer tabs to
hold panels into place.
TIGHTEN TABS UNTIL PANELS ARE SECURE.
!
OVER-TIGHTENING MAY DAMAGE THE
GLASS.
B
C
Advertisement
Table of Contents
