Cisco NCS 4216 Installing page 48

Hide thumbs Also See for NCS 4216:

Connecting to the Auxiliary Port

Procedure

Step 1

Run the setup.exe for Windows 32-bit or setup(x64).exe for Windows-64bit. Click Next.

Step 2

The InstallShield Wizard for Cisco Virtual Com appears. Click Next.

Step 3

When the Program Maintenance window appears, select the Remove radio button. Click Next.

Step 4

When the Remove the Program window appears, click Remove.

Note

Step 5

When the InstallShield Wizard Completed window appears click Finish.

Connecting to the Auxiliary Port

When a modem is connected to the auxiliary port, a remote user can dial in to the router and configure it. Use

a light blue console cable and the DB-9-to-DB-25 connector adapter.

Note

The console cable and DB-9-to-DB-25 connector are not included with the Cisco NCS 4216; they are ordered

separately.

To connect a modem to the router, follow these steps:

Procedure

Step 1

Connect the RJ45 end of the adapter cable to the black AUX port on the router, as shown in the figure below.

Installing the Cisco NCS 4216

If a User Account Control warning appears, click "Allow - I trust this program..." to proceed.

Installing the Cisco NCS 4216