Front Panel Description - AKG CM12/8 Manual

4. Front Panel Description

POWER SWITCH and LED
LCD DISPLAY
- Shows the available menus for configuring the CM12/8
SAVE Button
- Saves the current value of all CM12/8 parameters to nonvolatile memory. Used if
changes are made from the front panel which should become permanent. If the SAVE button is not
pressed after any changes, the changes will be lost when the power is removed from the CM12/8.
SELECT Button
- Moves the active cursor between menu categories.
UP and DOWN Buttons
the Up and Down buttons are both pushed while the power is turned on, the CM12/8 will be
returned to factory default condition. Factory defaults are as follows:
1) All input gains in all memories are set to Off.
2) All output gains in all memories are set to 0dB.
3) LCD display contrast is set to the factory default.
4) Operational mode is set to Local.
CM12/8 Menu Options:
CM12/8 LecNet Address
factory default address is 134.
In/Out Gain Adjust
the active memory is shown on the far right side of the first line. The active memory can be adjusted
from 1 to 9. The SAVE button will save the current setup to the active memory shown on this menu.
Display Contrast
- Allows the contrast ratio of the LCD display to be adjusted to accommodate
different viewing angles.
CM 12/ 8
MATRIX MIXER
Figure 3 - CM12/8 Front Panel
- Indicates that the CM12/8 has AC power and is turned on.
- Increments or decrements the values in the active menu category. If
- Allows the LecNet address of the CM12/8 to be changed. The
- Allows the input send levels and output levels to be adjusted. In addition,
1:
3:
SAVE SELECT DOWN UP
19
CM12/8
2:
4:
POWER