Non-Fault Code Troubleshooting; Cook Door Open - TurboChef Eco Service Manual

54 TROUBLESHOOTING

Non-Fault Code Troubleshooting

This section provides troubleshooting tips for issues that may occur independently of an oven fault.
Enter Test Mode (page
18) and observe the status
indicators when the door
closes. Do all three door
switches close in sequence
(P, S, M)?
NO
Check the door/door
hinge connection. Is
the door loose on the
hinge arms?
YES
Adjust/tighten the door
(page 34, section "Adjusting
the Oven Door").
Troubleshooting:
"Cook Door Open" Message when Door is Closed
Is "F4 MONITOR"
NO
fault present?
YES
Adjust the door switch(es) to
allow the switch(es) to close
NO
(page 35, section "Adjusting
the Primary, Secondary, and
Monitor Switches"). Is the
issue resolved?
Refer to the F4: MONITOR
troubleshooting procedures
YES
on page 50.
Is the wiring from the door
NO
switches to I/O control board
(Sage) OK?
YES
Replace the door Correct wiring or
switch(es). replace it if damaged.
NO