Non-Fault Code Troubleshooting; Door Open" Message When Door Is Closed - TurboChef Double Batch Service Manual

26 TROUBLESHOOTING

Non-Fault Code Troubleshooting

This section provides troubleshooting tips for issues that may occur independently of an oven fault.
Troubleshooting:

"Door Open" Message when Door is Closed

Check the door/door
hinge connection. Is
the door loose on the
hinge arms?
NO
Adjust the door switch(es)
to allow the switch(es) to
close (page 38, section "Door
Interlock Switches"). Is the
issue resolved?
Replace the door
switch(es).
Adjust/tighten the door
YES
(see Appendix for door
assembly detail, page A-4).
Is the wiring from the door switches
NO
to I/O control board (SAGE) OK?
NO
YES
Correct wiring or replace
it if damaged.