Editing; Cook More; Load Menu; Vac - TurboChef Eco Service Manual

14 INFO MODE

Editing

Edit Mode shows or hides the button that allows
the operator to change menu settings, rename
food groups and items, and change the cooking
temperature. The Edit icon will be displayed at the
bottom of the screen (page 7) when this option is
set to YES. See page 27 for more details on editing
menu settings.

Cook More

Cook More controls whether or not the three "cook
more" options appear when a cook cycle is done.
This option must be enabled in order to cook an
item beyond its original cook time. See page 10 for
details.

Load Menu

Load Menu enables or disables downloading new
menu settings from USB.

VAC

When VAC is set to YES the selected incoming
voltage will be displayed on the Info screen. This is
set by the factory and should not be changed, and
applies only within North America.

Demo Mode

Demo Mode is a feature used to demonstrate the
cooking features of the oven without turning on the
heaters or microwave system. Demo Mode must be
set to NO during regular operation.

Manual Cooking

When Manual Cooking is set to YES, the operator
can cook items "on the fly." See page 11 for more
details.

Diagnostic Mode

Diagnostic Mode allows the operator to view
and test oven components. This mode should
only be used by qualified service technicians,
unless otherwise instructed by TurboChef. When
Diagnostic Mode is turned on, the oven will show
the following information during cooking:
• Event currently being cooked
• % wave and % air
• Status indicators (see page 18)
• Cavity temperature
• CC set point
• Electrical compartment temperature
To turn Diagnostic Mode on or off, press the
key adjacent to "Diagnostic." For normal oven
operation, Diagnostic Mode should remain off.

F2 Bypass

The F2 alarm indicates the oven temperature is
too low. YES means the oven will not terminate
a cook cycle when an F2 alarm is encountered so
the food product can finish cooking. The oven will
still log the fault condition. NO means the oven
will function as it normally would; i.e., when an F2
alarm is discovered during a cook cycle, the oven
will terminate the cook cycle. See page 45 for more
information.