Controls & Components - Grizzly G0779 Owner's Manual

Controls &
Components
To reduce your risk of
serious injury, read this
entire
using machine.
Refer to Figures 1–3 and the following descrip-
tions to become familiar with the basic controls of
this machine.
Headstock
D
C
B
A
Figure 1. Headstock controls (right).
A. Depth Stop Adjustment Knob: Determines
depth of cut.
B. Depth Scale: Indicates depth of cut.
C. Depth Stop: Stops spindle travel at pre-
determined depth.
D. Spindle Switch: Turns machine ON and
OFF. Selects direction of spindle rotation.
E. Headstock Locking Nuts: Lock headstock
in position.
F. Coarse Downfeed Levers: Provide coarse
control over vertical spindle travel.
G. Downfeed Selector Knob: Engages/disen-
gages fine downfeed handwheel.
H. Fine Downfeed Handwheel: Provides fine
control over vertical spindle travel.
-4-
manual BEFORE
E
F
H
G
I
Figure 2. Headstock controls (left).
I. Headstock Elevation Crank: Changes ele-
vation of entire headstock.
J. Spindle Speed Range Selector: Selects
between low and high spindle speed ranges.
K. Spindle Speed Selector: Selects one of
three spindle speeds within each range.
L. Quill Lock: Locks quill in position.
Table
M
Figure 3. Table controls.
M. Table Elevation Lock Handles: Secure
table assembly to column. Unlock to raise or
lower table, or to pivot table assembly around
column.
N. Table Rotation Lock Handle: Allows table
to rotate.
O. Table Elevation Crank: Changes elevation
of table assembly.
Model G0779 (Mfd. Since 09/14)
J
K
L
N
O