Table of Contents
Advertisement
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Model G0779 (Mfd. Since 09/14)
Small Item Inventory (Figure 5)
A. Hex Wrench (3, 4, 5mm) ......................1 Ea.
B. Drift Key ...................................................... 1
C. Bottle for Oil ............................................... 1
D. Open-End Wrench 22–24mm..................... 1
E. Open-End Wrench 17–19mm ..................... 1
F.
Drill Chuck Key ........................................... 1
G. Drill Chuck B16, 1–13mm ........................... 1
H. Drill Chuck Arbor R-8–MT#3 ...................... 1
I.
Spindle Sleeve R-8–MT#3 ......................... 1
J.
Spindle Sleeve MT#3–MT#2 ...................... 1
K. Hardware Bag (Not Shown) ........................ 1
— Hex Nuts M12-1.75 .................................. 2
— T-Bolts M12-1.75 x 55.............................. 2
—Flat Washers 12mm ................................ 2
L. Toolbox (Not Shown) .................................. 1
A
G
F
H
E
Figure 5. Model G0779 toolbox contents.
Qty
B
C
J
I
D
-13-
Advertisement
Table of Contents
