Table of Contents
Advertisement
Installing Tooling
Tool Needed
Open-End Wrench 19mm .................................. 1
To install tooling:
1.
DISCONNECT MACHINE FROM POWER!
2.
Remove drawbar cap, as shown in Figure 19.
3.
Align tool alignment slot (see Figure 18 on
Page 22) with pin inside spindle, then insert
tooling into spindle until it contacts drawbar.
Note: Height of drawbar inside spindle can
be changed by rotating adjustment nut (see
Figure 19).
Drawbar Cap
Adjustment
Nut
Figure 19. Drawbar components used when
installing/removing tooling.
4.
Working from the top, thread drawbar into
tool by hand until it is snug, then use a 19mm
wrench to tighten it.
Note:
Do
not
Overtightening makes tool removal difficult
and will damage arbor and threads.
5.
Re-install drawbar cap.
Model G0779 (Mfd. Since 09/14)
Qty
Drawbar
overtighten
drawbar.
Removing Tooling
Tools Needed
Wrench 19mm ................................................... 1
Brass Head or Dead Blow Hammer .................. 1
To remove tooling:
1.
DISCONNECT MACHINE FROM POWER!
2.
Remove drawbar cap and unthread drawbar
from tool one full rotation.
Note: Do not fully unthread tool from drawbar,
or drawbar and tool threads could be dam-
aged in next step.
3.
Tap top of drawbar with hammer to unseat
taper.
4.
Hold onto tool with one hand and fully
unthread drawbar.
Qty
-23-
Advertisement
Table of Contents
