Mercedes-Benz S-Class Owner's Manual page 219

Point remote control 5 from a distance of
#
1 cm to 8 cm towards buttons 1,
Press and hold button 6 of remote control
#
5 until:
Indicator lamp 4 lights up green contin‐
R
uously. Programming is complete.
Indicator lamp 4 flashes green. Pro‐
R
gramming was successful. Additionally,
synchronisation of the rolling code with
the door system must also be carried out.
If indicator lamp 4 does not light up or flash
#
green: repeat the procedure.
Release all of the buttons.
#
% The remote control for the door drive is not
included in the scope of delivery of the
garage door opener.
Synchronising the rolling code
Requirements:
The door system uses a rolling code.
R
The vehicle must be within range of the
R
garage door or door drive.
The vehicle as well as persons and objects,
R
2 or 3. are located outside the range of movement
of the door.
Press the programming button on the door
#
drive unit.
Initiate the next step within approximately
30 seconds.
Driving and parking 217
Press previously programmed button 1,
#
or 3 repeatedly until the door closes.
When the door closes, programming is com‐
pleted.
% Please also read the operating instructions
for the door drive.
Troubleshooting when programming the
remote control
Check if the transmitter frequency of remote
#
control 5 is supported.
Replace the batteries in remote control 5.
#
Hold remote control 5 at various angles at
#
a distance between 1 cm to 8 cm in front of
2