Avaya J100 Series Installing And Administering page 281

Parameter name
PHY1STAT
PHY2_AUTOMDIX_ENABLED
PHY2PRIO
July 2019 Installing and Administering Avaya J100 Series IP Phones
Comments on this document? infodev@avaya.com
List of configuration parameters
Default Description
value
1 Specifies the speed and duplex
settings for the Ethernet line
interface.
Value operation:
• 1: auto-negotiate
• 2: 10Mbps half-duplex
• 3: 10Mbps full-duplex
• 4: 100Mbps half-duplex
• 5: 100Mbps full-duplex
• 6: 1Gbps full-duplex, if supported
by hardware, otherwise auto-
negotiated
1 Specifies whether auto-MDIX is
enabled on PHY2.
Value operation:
• 0: auto-MDIX is disabled.
• 1: auto-MDIX is enabled.
0 Specifies the layer 2 priority value
to be used for frames received on
the secondary Ethernet interface
when VLAN separation is enabled.
The parameter is not supported
when VLANSEPMODE is 1.
Valid values are 0 through 7.
Table continues...
281