Linksys EA2750 User Manual page 53

3. Under Router Settings, click Security, then click the DMZ tab.
4. Click the button for DMZ to turn it on.
5. In the Source IP Address section, select Any IP Address to allow access to your DMZ device
from the entire Internet, or select Specified Range and enter a range of allowed source
addresses.
6. In the Destination IP Address section, enter the last three digits of the IP address of the
device that will be in the DMZ. The rest of the IP address is already completed.
If you want to specify the 12-digit MAC address of the device instead of setting up a DHCP
address reservation, you can replace Step 6 with the following steps:
7. In the Destination IP Address section, select MAC Address, then click
Table . The DHCP Client Table screen opens.
8. Click Select next to the device that you want to place in the DMZ, then click Close. The
corresponding MAC address is copied into the MAC Address field.
9. Click Ok.
OR
View DHCP Client
53