Checking The Brake-Fluid Level; Inspecting The Brakes; Changing The Brake Fluid - Toro Workman 07040 Operator's Manual

Gtx gasoline/petrol utility vehicle, serial no. 401400001/400000000 and up
Hide thumbs Also See for Workman 07040:
Table of Contents

Advertisement

8.
Verify that the parking brake is adjusted to the
proper tension; refer to
Brake (page
50).
Note:
If you cannot adjust the parking brake
to the required tension, the brake pads may
be worn and need to be replace. Contact your
Authorized Service Dealer for assistance.
Checking the Brake-Fluid
Level
Service Interval: Before each use or daily Check the
brake-fluid level before the motor is
first used.
Brake Fluid Type: DOT 3
1.
Park the machine on a level surface.
2.
Engage the parking brake.
3.
Shut off the engine and remove the key.
4.
Raise the hood to gain access to the
master-brake cylinder and reservoir
Figure 62
1. Filler neck (reservoir)
2. Reservoir cap
5.
Look at the outline of the fluid level at the side of
the reservoir
(Figure
Note:
The level should be above the Minimum
line.
Checking the Parking
(Figure
3. DOT 3 brake fluid
63).
1. Brake-fluid reservoir
6.
If the fluid level is low, perform the following:
A.
Clean the area around the reservoir cap
and remove the cap
B.
Add DOT 3 brake fluid to the reservoir until
the fluid level is above the Minimum line
(Figure
Note:
62).
brake fluid.
C.
Install the reservoir cap
7.
Close the hood of the machine.

Inspecting the Brakes

Service Interval: Every 100 hours
Brakes are a critical safety component of the machine.
As with all safety components, they should be closely
inspected at regular intervals to ensure optimum
performance and safety.
Inspect the brake shoes and pads for wear or
damage. If the lining (brake pad) thickness is less
than 1.6 mm (1/16 inch), the brake shoes should
be replaced.
g034314
Inspect the backing plate and other components
for signs of excessive wear or deformation. If any
deformation is found, the appropriate components
must be replaced.
Check the brake-fluid level; refer to
Brake-Fluid Level (page

Changing the Brake Fluid

Service Interval: Every 1,000 hours
Refer to your authorized Authorized Service Dealer.
51
Figure 63
2. Minimum line
(Figure
62).
63).
Do not overfill the reservoir with
(Figure
Checking the
51).
g002136
62).

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents