Maintaining The Headlights - Toro Workman 07040 Operator's Manual

Maintaining the Headlights

Replacing the Bulbs
CAUTION
If you install a higher wattage bulb than the
system is designed for, you may blow the
fuse.
Always use the specified Toro LED bulb to
prevent this issue.
CAUTION
The bulbs become extremely hot when in
operation. Handling a hot bulb can cause
severe burns and personal injury.
Always allow enough time for the bulbs
to cool before replacing them. Use care
whenever handling the bulb.
Specification: See your Parts Catalog.
1. Disconnect the battery; refer to
the Battery (page
2. Open the hood; refer to
30).
3. Disconnect the electrical connector for the
harness from the connector of the lamp
assembly at the back of the headlight housing
(Figure 52).
Figure 52
1. Headlight housing
2. Lamp assembly
4. Rotate the lamp assembly 1/4 turn
counterclockwise and moving it rearward,
out of the headlight housing
5. Insert the new lamp assembly and headlight
housing and align the tabs in the lamp assembly
Disconnecting
41).
Raising the Hood (page
3. Harness-electrical
connector
(Figure 52).
with the slots in the headlight housing
52).
6. Secure lamp assembly by turning it 1/4 turn
clockwise
7. Connect the electrical connector for the harness
to the connector of the new lamp assembly
(Figure 52).
8. Connect the battery and close the hood; refer to
Connecting the Battery (page
Replacing the Headlight
1. Disconnect the battery; refer to
the Battery (page
2. Open the hood; refer to
30).
3. Disconnect the electrical connector for the
harness from the connector of the lamp
assembly
1. Speed clip
2. Opening in the bumper
3. Adjustment screw
4. Remove the speed clips that secure the
g035852
headlight to the headlight bracket
Note:
Retain all parts for installation of the new
headlight.
5. Remove the headlight assembly by moving it
forward through the opening in the front bumper
(Figure 53).
6. Install the new headlight through the opening in
the bumper
44
(Figure 52).
43).
Disconnecting
41).
Raising the Hood (page
(Figure 53).
Figure 53
4. Headlight
5. Lamp assembly
6. Harness-electrical
connector
(Figure 53).
(Figure
g035853
(Figure 53).